User Manual

Remote Commands
R&S
®
FPL1000
600User Manual 1178.3370.02 ─ 03
CALCulate<n>:PSEarch:SUBRanges <NumberPeaks>
CALCulate<n>:PEAKsearch:SUBRanges <NumberPeaks>
This command defines the number of peaks included in the peak list.
After this number of peaks has been found, the R&S FPL1000 stops the peak search
and continues the search in the next measurement range.
Suffix:
<n>
.
Window
Parameters:
<NumberPeaks> Range: 1 to 50
*RST: 25
Example:
CALC:PSE:SUBR 10
Sets 10 peaks per range to be stored in the list.
Manual operation: See " Peaks per Range " on page 337
8.6.7.4 Performing a Spurious Measurement
The following commands are required to perform a Spurious measurement:
SENS:SWE:MODE LIST, see [SENSe:]SWEep:MODE on page 564
INITiate<n>[:IMMediate] on page 536, see Chapter 8.6.1, "Performing Measure-
ments", on page 534
8.6.7.5 Retrieving and Saving Settings and Results
The following commands analyze and retrieve measurement results for Spurious mea-
surements.
Useful commands for spurious emission measurements described elsewhere
●
CALCulate<n>:LIMit<k>:FAIL? on page 782
●
TRACe<n>[:DATA] on page 703
●
TRACe<n>[:DATA]:MEMory? on page 704
●
TRACe<n>[:DATA]:X? on page 705
8.6.7.6 Programming Example: Spurious Emissions Measurement
In the following example, the Spurious Emissions measurement is configured by defin-
ing ranges and parameters to create the following sweep list.
Note that this example is primarily meant to demonstrate the remote control com-
mands, it does not necessarily reflect a useful measurement task.
//------------Preparing the measurement-------------
*RST
//Resets the instrument
Configuring and Performing Measurements