User Manual

Remote Commands
R&S
®
FPL1000
603User Manual 1178.3370.02 ─ 03
●
CALCulate<n>:MARKer<m>:X:SLIMits[:STATe]
Remote commands exclusive to time domain power measurements
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary:AOFF................................................... 603
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary:AVERage..............................................603
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary:PHOLd................................................. 604
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary[:STATe]................................................ 604
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary:MEAN[:STATe]......................................604
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary:PPEak[:STATe]..................................... 605
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary:RMS[:STATe]........................................ 605
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary:SDEViation[:STATe]...............................605
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary:AOFF
This command turns all time domain power evaluation modes off.
Suffix:
<n>
.
Window
<m> Marker
Usage: Event
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary:AVERage <State>
This command switches on or off averaging for the active power measurement in zero
span in the window specified by the suffix <n>. If activated, a time domain value is cal-
culated from the trace after each sweep; in the end, all values are averaged to calcu-
late the final result.
The number of results required for the calculation of average is defined with [SENSe:
]AVERage<n>:COUNt .
Averaging is reset by switching it off and on again.
Synchronization to the end of averaging is only possible in single sweep mode.
Suffix:
<n>
.
Window
<m> Marker
Parameters:
<State> ON | OFF | 1 | 0
*RST: 0
Configuring and Performing Measurements