User Manual

Remote Commands
R&S
®
FPL1000
623User Manual 1178.3370.02 ─ 03
[SENSe:]LIST:POWer:SET <PeakPower>, <RMSPower>, <AVGPower>,
<TriggerSource>, <TriggerSlope>, <TriggerOffset>, <GateLength>
This command defines global List Evaluation parameters.
These parameters are valid for every frequency you want to measure.
The state of the first three parameters (<PeakPower>, <RMSPower> and <AVG-
Power>) define the number of results for each frequency in the list.
Note that you have to set the trigger level after sending this command.
Parameters:
<PeakPower> ON | OFF | 0 | 1
Turns peak power evaluation on and off.
*RST: 1
<RMSPower> ON | OFF | 0 | 1
Turns RMS power evaluation on and off.
*RST: 0
<AVGPower> ON | OFF | 0 | 1
Turns average power evaluation on and off.
*RST: 0
<TriggerSource> Selects a trigger source.
<TriggerSlope> NEGative | POSitive
Selects the trigger slop.
<TriggerOffset> Defines the trigger delay.
Range: negative measurement time to 30 s
*RST: 0
Default unit: s
<GateLength> Defines the gate length for gated measurements.
Setting 0 seconds turns gated measurements off.
To perform gated measurements, the trigger source must be dif-
ferent from IMMediate.
Range: 31.25 ns to 30 s
*RST: 0 s
[SENSe:]LIST:POWer:STATe <State>
This command turns the List Evaluation off.
Parameters:
<State> OFF | 0
*RST: 0
Configuring and Performing Measurements