User Manual

Remote Commands

R&S

FPL1000

626User Manual 1178.3370.02 ─ 03

CALCulate<n>:MARKer<m>:FUNCtion:MSUMmary

This command configures power measurements on pulses in the time domain.

To evaluate the pulse power, the R&S FPL1000 uses the data captured during a previ-

ous measurement. The data recorded during the set measurement time is combined to

a measured value for each pulse according to the detector specified and the indicated

number of results is output as a list.

To get a valid result, you have to perform a complete measurement with synchroniza-

tion to the end of the measurement before reading out the result. This is only possible

for single sweep mode.

See also INITiate<n>:CONTinuous on page 536.

Suffix:

<n>

Window

<m> Marker

Parameters:

<TimeOffset> Defines a time offset to start the measurement at the first pulse

of a trace.

*RST: 0

Default unit: s

<MeasTime> Defines the measurement time.

Default unit: s

<PulsePeriod> Defines the pulse period

<#OfPulses> Defines the number of pulses to measure.

Example:

CALC:MARK:FUNC:MSUM 50US,450US,576.9US,8

Evaluates data that contains 8 pulses during a measurement

time of 450 µs and a pulse period of 576.9 µs. The evaluation

starts with an offset of 50 µs.

[SENSe:]MPOWer:FTYPe <FilterType>

This command selects the filter type for pulse power measurements.

Configuring and Performing Measurements