User Manual

ManualsBrandsRohde & Schwarz ManualsSignal Generators & Spectrum AnalysersSpectrum Analyser Full Package, 3GHz, 50Ohm

641

642

643

644

645

646

647

648

649

650

Remote Commands

R&S

FPL1000

641User Manual 1178.3370.02 ─ 03

● Configuring the Trace Display and Retrieving Trace Data....................................687

● Working with Markers............................................................................................708

● Configuring Display and Limit Lines......................................................................767

8.8.1 Defining the Frequency and Span

The commands required to configure the frequency and span settings in a remote envi-

ronment are described here. The tasks for manual operation are described in Chap-

ter 7.4, "Frequency and Span Configuration", on page 375.

● Defining the Frequency Range............................................................................. 641

● Adjusting Settings Automatically...........................................................................645

● Configuring Signal Tracking..................................................................................648

8.8.1.1 Defining the Frequency Range

CALCulate<n>:MARKer<m>:FUNCtion:CENTer................................................................641

CALCulate<n>:MARKer<m>:FUNCtion:CSTep................................................................. 642

DISPlay[:WINDow<n>]:TRACe:X:SPACing.......................................................................642

[SENSe:]FREQuency:CENTer.........................................................................................642

[SENSe:]FREQuency:CENTer:STEP............................................................................... 643

[SENSe:]FREQuency:CENTer:STEP:AUTO..................................................................... 643

[SENSe:]FREQuency:CENTer:STEP:LINK....................................................................... 643

[SENSe:]FREQuency:CENTer:STEP:LINK:FACTor...........................................................644

[SENSe:]FREQuency:OFFSet.........................................................................................644

[SENSe:]FREQuency:SPAN............................................................................................644

[SENSe:]FREQuency:SPAN:FULL...................................................................................645

[SENSe:]FREQuency:STARt...........................................................................................645

[SENSe:]FREQuency:STOP............................................................................................645

CALCulate<n>:MARKer<m>:FUNCtion:CENTer

This command matches the center frequency to the frequency of a marker.

If you use the command in combination with a delta marker, that delta marker is turned

into a normal marker.

Suffix:

<n>

Window

<m> Marker

Example:

CALC:MARK2:FUNC:CENT

Sets the center frequency to the frequency of marker 2.

Usage: Event

Manual operation: See " Center Frequency = Marker Frequency " on page 437

Setting Basic Spectrum RF Measurement Parameters