User Manual

Remote Commands
R&S
®
FPL1000
645User Manual 1178.3370.02 ─ 03
Manual operation: See " Zero Span " on page 233
See " Span " on page 377
See " Zero Span " on page 378
See " Last Span " on page 378
[SENSe:]FREQuency:SPAN:FULL
This command restores the full span.
Usage: Event
Manual operation: See " Full Span " on page 378
[SENSe:]FREQuency:STARt
<Frequency>
This command defines a start frequency for measurements in the frequency domain.
Parameters:
<Frequency> 0 to (fmax - min span)
*RST: 0
Example:
FREQ:STAR 20MHz
Manual operation: See " Frequency Sweep " on page 233
See " Start / Stop " on page 378
[SENSe:]FREQuency:STOP <Frequency>
This command defines a stop frequency for measurements in the frequency domain.
Parameters:
<Frequency> min span to fmax
*RST: fmax
Example:
FREQ:STOP 2000 MHz
Manual operation: See " Frequency Sweep " on page 233
See " Start / Stop " on page 378
8.8.1.2 Adjusting Settings Automatically
The commands required to adjust settings automatically in a remote environment are
described here.
[SENSe:]ADJust:ALL......................................................................................................646
[SENSe:]ADJust:CONFigure[:LEVel]:DURation.................................................................646
[SENSe:]ADJust:CONFigure[:LEVel]:DURation:MODE...................................................... 646
[SENSe:]ADJust:CONFigure:HYSTeresis:LOWer..............................................................647
[SENSe:]ADJust:CONFigure:HYSTeresis:UPPer...............................................................647
[SENSe:]ADJust:CONFigure:TRIGger..............................................................................647
[SENSe:]ADJust:FREQuency..........................................................................................648
[SENSe:]ADJust:LEVel...................................................................................................648
Setting Basic Spectrum RF Measurement Parameters