User Manual

ManualsBrandsRohde & Schwarz ManualsSignal Generators & Spectrum AnalysersSpectrum Analyser Full Package, 3GHz, 50Ohm

641

642

643

644

645

646

647

648

649

650

Remote Commands

R&S

FPL1000

650User Manual 1178.3370.02 ─ 03

Manual operation: See " Signal Tracking " on page 380

8.8.2 Configuring Bandwidth and Sweep Settings

The commands required to configure the bandwidth, sweep and filter settings in a

remote environment are described here. The tasks for manual operation are described

in Chapter 7.6, "Bandwidth, Filter and Sweep Configuration", on page 390.

● Configuring the Bandwidth and Filter....................................................................650

● Configuring the Sweep..........................................................................................653

8.8.2.1 Configuring the Bandwidth and Filter

[SENSe:]BWIDth[:RESolution].........................................................................................650

[SENSe:]BANDwidth[:RESolution]................................................................................... 650

[SENSe:]BWIDth[:RESolution]:AUTO...............................................................................651

[SENSe:]BANDwidth[:RESolution]:AUTO..........................................................................651

[SENSe:]BWIDth[:RESolution]:RATio...............................................................................651

[SENSe:]BANDwidth[:RESolution]:RATio..........................................................................651

[SENSe:]BWIDth[:RESolution]:TYPE................................................................................651

[SENSe:]BANDwidth[:RESolution]:TYPE.......................................................................... 651

[SENSe:]BWIDth:VIDeo..................................................................................................652

[SENSe:]BANDwidth:VIDeo............................................................................................ 652

[SENSe:]BWIDth:VIDeo:AUTO........................................................................................652

[SENSe:]BANDwidth:VIDeo:AUTO...................................................................................652

[SENSe:]BWIDth:VIDeo:RATio........................................................................................652

[SENSe:]BANDwidth:VIDeo:RATio...................................................................................652

[SENSe:]BWIDth:VIDeo:TYPE.........................................................................................652

[SENSe:]BANDwidth:VIDeo:TYPE................................................................................... 652

[SENSe:]BWIDth[:RESolution] <Bandwidth>

[SENSe:]BANDwidth[:RESolution] <Bandwidth>

This command defines the resolution bandwidth and decouples the resolution band-

width from the span.

For statistics measurements, this command defines the demodulation bandwidth.

Parameters:

<Bandwidth> refer to data sheet

*RST: RBW: AUTO is set to ON; DBW: 3MHz

Example:

BAND 1 MHz

Sets the resolution bandwidth to 1 MHz

Manual operation: See " RBW " on page 397

See " RBW " on page 410

Setting Basic Spectrum RF Measurement Parameters