User Manual

Getting Started
R&S
®
FPL1000
66User Manual 1178.3370.02 ─ 03
TRG Trigger source
(for details see "Trigger settings" in the User Manual)
●
EXT: External
●
IFP: IF power (+trigger bandwidth)
●
PSE: Power sensor
●
TIM: Time
●
VID: Video
PA The preamplifier is activated.
GAT The frequency sweep is controlled via the TRIGGER INPUT connector.
TDF A transducer factor is activated.
75 Ω The input impedance of the instrument is set to 75 Ω.
FRQ A frequency offset ≠ 0 Hz is set.
Changing the Channel Setup Name
The channel setups are labeled with their default name. If that name already exists, a
sequential number is added. You can change the name of the channel setup by dou-
ble-tapping the name in the channel bar and entering a new name.
For an overview of default names, see INSTrument:LIST? on page 528.
Remote command:
INSTrument:REName on page 529
4.4.1.2 Window Title Bar
Each channel in the R&S FPL1000 display can contain several windows. Each window
can display either a graph or a table as a result of the channel measurement. The win-
dow title bar indicates which type of evaluation is displayed.
Which type of result evaluation is displayed in which window is defined in the display
configuration (see Chapter 7.2.2, "Basic Evaluation Methods", on page 253).
Trace Information in Window Title Bar
Information on the displayed traces is indicated in the window title bar.
2
1 3 4 5
(1) Trace color Color of trace display in diagram
(2) Trace no. Trace number (1 to 6)
(3) Detector Selected detector:
AP AUTOPEAK detector
Pk MAX PEAK detector
Mi MIN PEAK detector
Operating the Instrument