User Manual

Getting Started
R&S
®
FPL1000
67User Manual 1178.3370.02 ─ 03
Sa SAMPLE detector
Av AVERAGE detector
Rm RMS detector
(4) Trace Mode Sweep mode:
Clrw CLEAR/WRITE
Max MAX HOLD
Min MIN HOLD
Avg AVERAGE (Lin/Log/Pwr)
View VIEW
(5) Smoothing factor Smth Smoothing factor, if enabled.
(See " Smoothing " on page 468)
4.4.1.3 Marker Information
Marker information is provided either in the diagram grid or in a separate marker table,
depending on the configuration.
Marker information in diagram grid
Within the diagram grid, the x-axis and y-axis positions of the last two markers or delta
markers that were set are displayed, if available, as well as their index. The value in
the square brackets after the index indicates the trace to which the marker is assigned.
(Example: M2[1] defines marker 2 on trace 1.) For more than two markers, a separate
marker table is displayed beneath the diagram by default.
Marker information in marker table
In addition to the marker information displayed within the diagram grid, a separate
marker table may be displayed beneath the diagram. This table provides the following
information for all active markers:
"Type" Marker type: N (normal), D (delta), T (temporary, internal), PWR (power sensor)
"Ref" Reference (for delta markers)
"Trc" Trace to which the marker is assigned
"X-value" X-value of the marker
"Y-Value" Y-value of the marker
"Function" Activated marker or measurement function
"Function Result" Result of the active marker or measurement function
The functions are indicated with the following abbreviations:
Operating the Instrument