User Manual

Remote Commands
R&S
®
FPL1000
692User Manual 1178.3370.02 ─ 03
Manual operation: See " Average Mode " on page 468
[SENSe:][WINDow<n>:]DETector<t>[:FUNCtion] <Detector>
Defines the trace detector to be used for trace analysis.
For details see "Mapping Samples to sweep Points with the Trace Detector"
on page 460.
Suffix:
<n>
.
Window
<t> Trace
Parameters:
<Detector> APEak
Autopeak
NEGative
Negative peak
POSitive
Positive peak
SAMPle
First value detected per trace point
RMS
RMS value
AVERage
Average
*RST:
APEak
Example:
DET POS
Sets the detector to "positive peak".
Manual operation: See " Detector " on page 467
[SENSe:][WINDow<n>:]DETector<t>[:FUNCtion]:AUTO <State>
This command couples and decouples the detector to the trace mode.
Suffix:
<n>
.
Window
<t> Trace
Parameters:
<State> ON | OFF | 0 | 1
*RST: 1
Example:
DET:AUTO OFF
The selection of the detector is not coupled to the trace mode.
Manual operation: See " Detector " on page 467
Setting Basic Spectrum RF Measurement Parameters