User Manual

Remote Commands
R&S
®
FPL1000
694User Manual 1178.3370.02 ─ 03
CALCulate<n>:SGRam[:STATe]......................................................................................696
CALCulate<n>:SPECtrogram[:STATe]............................................................................. 696
CALCulate<n>:SGRam:TSTamp:DATA?..........................................................................696
CALCulate<n>:SPECtrogram:TSTamp:DATA?................................................................. 696
CALCulate<n>:SGRam:TSTamp[:STATe]........................................................................ 697
CALCulate<n>:SPECtrogram:TSTamp[:STATe]................................................................697
CALCulate<n>:SGRam:CLEar[:IMMediate]
CALCulate<n>:SPECtrogram:CLEar[:IMMediate]
This command resets the spectrogram and clears the history buffer.
Suffix:
<n>
.
irrelevant
Example:
CALC:SGR:CLE
Resets the result display and clears the memory.
Usage: Event
Manual operation: See " Clear Spectrogram " on page 403
CALCulate<n>:SGRam:CONTinuous <State>
CALCulate<n>:SPECtrogram:CONTinuous <State>
This command determines whether the results of the last measurement are deleted
before starting a new measurement in single sweep mode.
This setting applies to all spectrograms in the channel setup.
Suffix:
<n>
.
irrelevant
Parameters:
<State> 1 | 0 | ON | OFF
1 | ON
0 | OFF
*RST: 0
Example:
INIT:CONT OFF
Selects single sweep mode.
INIT;*WAI
Starts the sweep and waits for the end of the sweep.
CALC:SGR:CONT ON
Repeats the single sweep measurement without deleting the
results of the last measurement.
Manual operation: See " Continue Frame " on page 402
CALCulate<n>:SGRam:FRAMe:COUNt <Frames>
CALCulate<n>:SPECtrogram:FRAMe:COUNt <Frames>
This command defines the number of frames to be recorded in a single sweep.
Setting Basic Spectrum RF Measurement Parameters