User Manual

Remote Commands
R&S
®
FPL1000
696User Manual 1178.3370.02 ─ 03
Parameters:
<History> The maximum number of frames depends on the number of
sweep points.
Range: 781 to 20000
Increment: 1
*RST: 3000
Example:
CALC:SGR:SPEC 1500
Sets the history depth to 1500.
Manual operation: See " History Depth " on page 480
CALCulate<n>:SGRam:LAYout <State>
CALCulate<n>:SPECtrogram:LAYout <State>
This command selects the state and size of spectrograms.
The command is available for result displays that support spectrograms.
Suffix:
<n>
.
Window
Parameters:
<State> ON
Spectrogram and trace diagram share a window.
OFF
Only the trace diagram is displayed, the spectrogram is not.
*RST: OFF
Example:
CALC4:SPEC:LAY FULL
Shows the spectrogram in window 4. The corresponding trace
diagram is hidden.
CALCulate<n>:SGRam[:STATe] <State>
CALCulate<n>:SPECtrogram[:STATe] <State>
This command turns the spectrogram on and off.
Parameters:
<State> ON | OFF | 1 | 0
*RST: 0
Example:
CALC:SGR ON
Activates the Spectrogram result display.
CALCulate<n>:SGRam:TSTamp:DATA? <Frames>
CALCulate<n>:SPECtrogram:TSTamp:DATA? <Frames>
This command queries the starting time of the frames.
Setting Basic Spectrum RF Measurement Parameters