User Manual

Remote Commands
R&S
®
FPL1000
717User Manual 1178.3370.02 ─ 03
Manual operation: See " Peak Excursion " on page 431
CALCulate<n>:MARKer<m>:X:SLIMits[:STATe] <State>
This command turns marker search limits on and off for all markers in all windows.
If you perform a measurement in the time domain, this command limits the range of the
trace to be analyzed.
Suffix:
<n>, <m>
.
irrelevant
Parameters:
<State> ON | OFF | 1 | 0
*RST: 0
Example:
CALC:MARK:X:SLIM ON
Switches on search limitation.
Manual operation: See " Search Limits ( Left / Right )" on page 285
See " Deactivating All Search Limits " on page 285
See " Limit State " on page 342
CALCulate<n>:MARKer<m>:X:SLIMits:LEFT <SearchLimit>
This command defines the left limit of the marker search range for all markers in all
windows.
If you perform a measurement in the time domain, this command limits the range of the
trace to be analyzed.
Suffix:
<n>, <m>
.
irrelevant
Parameters:
<SearchLimit> The value range depends on the frequency range or sweep
time.
The unit is Hz for frequency domain measurements and s for
time domain measurements.
*RST: left diagram border
Example:
CALC:MARK:X:SLIM ON
Switches the search limit function on.
CALC:MARK:X:SLIM:LEFT 10MHz
Sets the left limit of the search range to 10 MHz.
Manual operation: See " Search Limits ( Left / Right )" on page 285
See " Left Limit / Right Limit " on page 342
CALCulate<n>:MARKer<m>:X:SLIMits:RIGHt <SearchLimit>
This command defines the right limit of the marker search range for all markers in all
windows.
Setting Basic Spectrum RF Measurement Parameters