User Manual

Remote Commands
R&S
®
FPL1000
747User Manual 1178.3370.02 ─ 03
CALCulate<n>:MARKer<m>:FUNCtion:PNOise[:STATe] <State>
This command turns the phase noise measurement at the marker position on and off in
the Analog Demodulation application.
Suffix:
<n>
.
Window
<m> Marker
Parameters:
<State> ON | OFF | 1 | 0
*RST: 0
Example:
CALC:MARK2:FUNC:PNO ON
Switches on the phase-noise measurement for the marker 2.
8.8.8.11 Band Power Marker
The following commands control the marker for band power measurements.
Using Markers
CALCulate<n>:MARKer<m>:FUNCtion:BPOWer:MODE....................................................747
CALCulate<n>:MARKer<m>:FUNCtion:BPOWer:RESult?..................................................748
CALCulate<n>:MARKer<m>:FUNCtion:BPOWer:SPAN.....................................................748
CALCulate<n>:MARKer<m>:FUNCtion:BPOWer[:STATe]..................................................748
CALCulate<n>:MARKer<m>:FUNCtion:BPOWer:MODE <Mode>
This command selects the way the results for a band power marker are displayed.
(Note: relative power results are only availabe for delta markers, see CALCulate<n>:
DELTamarker<m>:FUNCtion:BPOWer:MODE on page 749.
Suffix:
<n>
.
Window
<m> Marker
Parameters:
<Mode> POWer
Result is displayed as an absolute power. The power unit
depends on the CALCulate<n>:UNIT:POWer setting.
setting.
DENSity
Result is displayed as a density in dBm/Hz.
*RST: POWer
Example:
CALC:MARK4:FUNC:BPOW:MODE DENS
Configures marker 4 to show the measurement results in
dBm/Hz.
Manual operation: See " Power Mode " on page 451
Setting Basic Spectrum RF Measurement Parameters