User Manual

Remote Commands
R&S
®
FPL1000
767User Manual 1178.3370.02 ─ 03
8.8.9 Configuring Display and Limit Lines
The commands required to configure display and limit lines in a remote environment
are described here.
● Configuring Display Lines..................................................................................... 767
● Defining Limit Checks........................................................................................... 769
8.8.9.1 Configuring Display Lines
The following commands configure vertical and horizontal display lines.
CALCulate<n>:DLINe<k>................................................................................................767
CALCulate<n>:DLINe<k>:STATe.....................................................................................767
CALCulate<n>:FLINe<k>................................................................................................768
CALCulate<n>:FLINe<k>:STATe.....................................................................................768
CALCulate<n>:TLINe<k>................................................................................................768
CALCulate<n>:TLINe<k>:STATe.....................................................................................769
CALCulate<n>:DLINe<k> <Position>
This command defines the (vertical) position of a display line.
Suffix:
<n>
.
Window
<k> Limit line
Parameters:
<Position> The value range is variable.
You can use any unit you want, the R&S FPL1000 then converts
the unit to the currently selected unit. If you omit a unit, the
R&S FPL1000 uses the currently selected unit.
*RST: (state is OFF)
Example:
CALC:DLIN2 -20dBm
Positions the second display line at -20 dBm.
Manual operation: See " Horizontal Line 1 / Horizontal Line 2 " on page 490
CALCulate<n>:DLINe<k>:STATe <State>
This command turns a display line on and off
Suffix:
<n>
.
Window
<k> Limit line
Parameters:
<State> ON | OFF | 1 | 0
*RST: 0
Setting Basic Spectrum RF Measurement Parameters