User Manual

Remote Commands
R&S
®
FPL1000
770User Manual 1178.3370.02 ─ 03
CALCulate<n>:LIMit<k>:UPPer[:DATA]............................................................................776
CALCulate<n>:LIMit<k>:UPPer:MARGin.......................................................................... 776
CALCulate<n>:LIMit<k>:UPPer:MODE.............................................................................776
CALCulate<n>:LIMit<k>:UPPer:OFFSet...........................................................................777
CALCulate<n>:LIMit<k>:UPPer:SHIFt.............................................................................. 777
CALCulate<n>:LIMit<k>:UPPer:SPACing......................................................................... 778
CALCulate<n>:LIMit<k>:UPPer:STATe............................................................................ 778
CALCulate<n>:LIMit<k>:UPPer:THReshold...................................................................... 778
CALCulate<n>:LIMit<k>:COMMent <Comment>
This command defines a comment for a limit line.
Suffix:
<n>
.
irrelevant
<k> Limit line
Parameters:
<Comment> String containing the description of the limit line.
Manual operation: See " Comment " on page 499
CALCulate<n>:LIMit<k>:CONTrol[:DATA] <LimitLinePoints>
This command defines the horizontal definition points of a limit line.
Suffix:
<n>
.
irrelevant
<k> Limit line
Parameters:
<LimitLinePoints> Variable number of x-axis values.
Note that the number of horizontal values has to be the same as
the number of vertical values set with CALCulate<n>:
LIMit<k>:LOWer[:DATA] or CALCulate<n>:LIMit<k>:
UPPer[:DATA]. If not, the R&S FPL1000 either adds missing
values or ignores surplus values.
The unit is Hz or s.
*RST: -
Manual operation: See " Data Points " on page 500
CALCulate<n>:LIMit<k>:CONTrol:DOMain <Type>
This command selects the domain of the limit line.
Suffix:
<n>
.
irrelevant
<k> Limit line
Setting Basic Spectrum RF Measurement Parameters