User Manual

Remote Commands
R&S
®
FPL1000
772User Manual 1178.3370.02 ─ 03
CALCulate<n>:LIMit<k>:CONTrol:SHIFt <Distance>
This command moves a complete limit line horizontally.
Compared to defining an offset, this command actually changes the limit line definition
points by the value you define.
Suffix:
<n>
.
irrelevant
<k> Limit line
Parameters:
<Distance> Numeric value.
The unit depends on the scale of the x-axis.
Manual operation: See " Shift x " on page 501
CALCulate<n>:LIMit<k>:CONTrol:SPACing <InterpolMode>
This command selects linear or logarithmic interpolation for the calculation of limit lines
from one horizontal point to the next.
Suffix:
<n>
.
Window
<k> Limit line
Parameters:
<InterpolMode> LINear | LOGarithmic
*RST: LIN
Example:
CALC:LIM:CONT:SPAC LIN
Manual operation: See " X-Axis " on page 500
CALCulate<n>:LIMit<k>:LOWer[:DATA] <LimitLinePoints>
This command defines the vertical definition points of a lower limit line.
Suffix:
<n>
.
irrelevant
<k> Limit line
Parameters:
<LimitLinePoints> Variable number of level values.
Note that the number of vertical values has to be the same as
the number of horizontal values set with CALCulate<n>:
LIMit<k>:CONTrol[:DATA]. If not, the R&S FPL1000 either
adds missing values or ignores surplus values.
The unit depends on CALCulate<n>:LIMit<k>:UNIT
on page 775.
*RST: Limit line state is OFF
Setting Basic Spectrum RF Measurement Parameters