User Manual

Remote Commands
R&S
®
FPL1000
774User Manual 1178.3370.02 ─ 03
Parameters:
<Offset> Numeric value.
*RST: 0
Default unit: dB
Manual operation: See " Y-Offset " on page 498
CALCulate<n>:LIMit<k>:LOWer:SHIFt <Distance>
This command moves a complete lower limit line vertically.
Compared to defining an offset, this command actually changes the limit line definition
points by the value you define.
Suffix:
<n>
.
Window
<k> Limit line
Parameters:
<Distance> Defines the distance that the limit line moves.
The unit depends on CALCulate<n>:LIMit<k>:UNIT
on page 775.
Manual operation: See " Shift y " on page 501
CALCulate<n>:LIMit<k>:LOWer:SPACing <InterpolType>
This command selects linear or logarithmic interpolation for the calculation of a lower
limit line from one horizontal point to the next.
Suffix:
<n>
.
Window
<k> Limit line
Parameters:
<InterpolType> LINear | LOGarithmic
*RST: LIN
Manual operation: See " Y-Axis " on page 500
CALCulate<n>:LIMit<k>:LOWer:STATe <State>
This command turns a lower limit line on and off.
Before you can use the command, you have to select a limit line with CALCulate<n>:
LIMit<k>:NAME on page 775.
Suffix:
<n>
.
irrelevant
<k> Limit line
Setting Basic Spectrum RF Measurement Parameters