User Manual

Remote Commands
R&S
®
FPL1000
811User Manual 1178.3370.02 ─ 03
Useful commands for storing results described elsewhere:
●
FORMat[:DATA] on page 702
Remote commands exclusive to storing results:
FORMat:DEXPort:HEADer..............................................................................................811
FORMat:DEXPort:TRACes............................................................................................. 811
MMEMory:STORe<n>:LIST............................................................................................ 812
MMEMory:STORe<n>:PEAK...........................................................................................812
MMEMory:STORe<n>:SGRam........................................................................................812
MMEMory:STORe<n>:SPECtrogram............................................................................... 812
MMEMory:STORe<n>:SPURious.................................................................................... 813
MMEMory:STORe<n>:TRACe.........................................................................................813
FORMat:DEXPort:HEADer <State>
If enabled, additional instrument and measurement settings are included in the header
of the export file for result data. If disabled, only the pure result data from the selected
traces and tables is exported.
See Chapter 7.13.4, "Reference: ASCII File Export Format", on page 515 for details.
Parameters:
<State> ON | OFF | 0 | 1
*RST: 1
Manual operation: See " Include Instrument & Measurement Settings " on page 513
FORMat:DEXPort:TRACes <Selection>
This command selects the data to be included in a data export file (see MMEMory:
STORe<n>:TRACe on page 813).
For details on exporting data see Chapter 7.13.1, "Trace / Data Export Configuration",
on page 512.
Parameters:
<Selection> SINGle
Only a single trace is selected for export, namely the one speci-
fied by the MMEMory:STORe<n>:TRACe command.
ALL
Selects all active traces and result tables (e.g. Result Summary,
marker peak list etc.) in the current application for export to an
ASCII file.
The <trace> parameter for the MMEMory:STORe<n>:TRACe
command is ignored.
*RST: SINGle
Manual operation: See " Export all Traces and all Table Results " on page 513
Managing Settings and Results