User Manual

Remote Commands
R&S
®
FPL1000
839User Manual 1178.3370.02 ─ 03
Example:
SYST:FORM:IDEN LEG
Adapts the return value of *IDN? to the R&S FSP/FSU/FSQ fam-
ily.
SYSTem:PRESet:COMPatible <OpMode>
This command defines the operating mode that is activated when you switch on the
R&S FPL1000 or press the PRESET key.
Parameters:
<OpMode> SANalyzer
(Default:)
Defines Signal and Spectrum Analyzer operating mode as the
presetting.
Manual operation: See " Preset Mode " on page 141
8.10.8 Using Service Functions
DIAGnostic:SERVice:SFUNction..................................................................................... 839
DIAGnostic:SERVice:SFUNction:LASTresult?...................................................................839
DIAGnostic:SERVice:SFUNction:RESults:DELete............................................................. 840
DIAGnostic:SERVice:SFUNction:RESults:SAVE............................................................... 840
DIAGnostic:SERVice:SINFo?.......................................................................................... 840
DIAGnostic:SERVice:SFUNction <ServiceFunction>
This command starts a service function.
The service functions are available after you have entered the level 1 or level 2 system
password.
Parameters:
<ServiceFunction> String containing the ID of the service function.
The ID of the service function is made up out of five numbers,
separated by a point.
• function group number
• board number
• function number
• parameter 1 (see the Service Manual)
• parameter 2 (see the Service Manual)
Usage: Event
Manual operation: See " Service Function " on page 146
See " Send " on page 146
DIAGnostic:SERVice:SFUNction:LASTresult?
This command queries the results of the most recent service function you have used.
Configuring the R&S FPL1000