User's Manual Part 1
Table Of Contents
- System Manual
- R&S®NV830x DTV Transmitters ATSC
- Volume 1
- Contents
- Safety Instructions
- Design and Characteristics
- Contents
- 1 Design and Function
- 2 Specifications
- Installation
- Contents
- 1 Equipment Supplied 1
- 2 Overview 3
- 3 Setting Up Transmitter 4
- 4 Ventilation System 9
- 5 AC Power Supply 14
- 6 Amplifiers 19
- 7 Connecting Antenna/Dummy Antenna to RF Connector 20
- 8 Connection Panel 23
- 1 Equipment Supplied
- 2 Overview
- 3 Setting Up Transmitter
- 4 Ventilation System
- 5 AC Power Supply
- 6 Amplifiers
- 7 Connecting Antenna/Dummy Antenna to RF Connector
- 8 Connection Panel
- Contents
- Commissioning
- Contents
- 1 General Information 1
- 2 Preparing for Transmitter Startup 3
- 2.1 Preparing for Local Operation 3
- 2.2 Checking and Setting System and Operating Parameters 3
- 2.3 R&S NetCCU800 3
- 2.4 Setting Transmitter Type 9
- 2.5 Entering Exciter Settings 11
- 2.6 Entering Output Stage Settings 19
- 2.7 Setting Transmitter Output Power 21
- 2.8 Calibrating Power Displays 22
- 3 Completion of Startup Procedure 26
- 4 Precorrection 31
- 1 General Information
- 2 Preparing for Transmitter Startup
- 2.1 Preparing for Local Operation
- 2.2 Checking and Setting System and Operating Parameters
- 2.3 R&S NetCCU800
- 2.4 Setting Transmitter Type
- 2.5 Entering Exciter Settings
- 2.6 Entering Output Stage Settings
- 2.7 Setting Transmitter Output Power
- 2.8 Calibrating Power Displays
- 3 Completion of Startup Procedure
- 4 Precorrection
- Contents
Chapter 4 Commissioning
2098.0188.72 - 4.7 - E-1
Select NetCCU > Setup > NetCCU Setup > Network > Front Ethernet.
The Front Ethernet window opens.
The Front Ethernet window displays the following network settings:
Notes
All settings for the front Ethernet interface are preset. If a PC/laptop is to be connected, the
network interface on the PC/laptop must be configured accordingly:
– IP address (PC): First three segments same as those for IP Address of the R&S
NetCCU800 (see above); a value below 250 must be entered for the last segment
– Subnet mask (PC): Same settings as under Network Mask (see above)
2.3.5.2 Rear Ethernet Interface (NETLINK)
Configure the NETLINK interface (X5) on the rear panel of the R&S NetCCU800 if you want
to connect the transmitter to a LAN/WAN.
Display Explanation
IP Address IP address of the network card
Network Mask Subnet mask of the network card
Speed Mode Speed and duplex
Factory setting: 10 Mbit / half duplex
Autosensing Autonegotiation ON/OFF
Factory setting: On
Autonegotiation = Automatic determination of the settings for the net-
work card
MAC Address Unique ID of the network card