User Manual

Putting into Operation

R&S

RT-ZHD07/15/16/60

21User Manual 1800.2588.02 ─ 01

2.1 Installation

This section introduces the use of the R&S RT-ZHD high voltage differential probe,

which has been designed for use with Rohde & Schwarz oscilloscopes.

Supported oscilloscopes

All settings of the base unit described in this section refer to Rohde & Schwarz oscillo-

scopes. These base units support the full software functionality of the R&S RT-ZHD

probes. If any other oscilloscope is used, differences in settings and menu navigation

may be possible.

For further information see the data sheet.

2.2 Connecting the Probe to the Oscilloscope

The R&S RT-ZHD high voltage differential probe has been designed for use with-

Rohde & Schwarz oscilloscopes.

1. Connect the probe box (1) to the Rohde & Schwarz probe interface of the base unit

(2). The probe snaps in when connected properly to the port.

Figure 2-1: Connecting the probe to the Rohde

Schwarz oscilloscope

2. To disconnect, press the release button (3) and pull the probe box away from the

front panel of the base unit.

3. Ensure that the R&S RT-ZHD and the scope working properly by checking the per-

formance, see Chapter 7, "Functional Check", on page 44.

In this example, the scope must show a rectangle signal with about 1 V

Connecting the Probe to the Oscilloscope