User Manual

Spectrum Analysis
R&S
®
Scope Rider RTH
116User Manual 1326.1578.02 ─ 08
Remote command:
SPECtrum:WAVeform:MAXimum[:ENABle] on page 311
SPECtrum:WAVeform:MINimum[:ENABle] on page 311
SPECtrum:WAVeform:SPECtrum[:ENABle] on page 311
SPECtrum:WAVeform:AVERage[:ENABle] on page 310
SPECtrum:FREQuency:AVERage:COUNt on page 308
Reset
Clears the results for previous measurements used in statistical evaluation (see Trace
mode (Clear/Write/ Max Hold/ Min Hold/Average )).
Remote command:
SPECtrum:FREQuency:RESet on page 311
5.2.5 Vertical Settings
You can configure the vertical settings for the input signal in Scope mode. When you
select the Spectrum mode, the configuration is maintained. Some additional vertical
settings are available in Spectrum mode.
The AUTOSET function sets the center frequency to the frequency with the highest
measured power. All other vertical settings are set to allow for an optimal spectrum dis-
play.
The following vertical settings are identical to Scope mode:
●
"Coupling" on page 39
●
"Probe Setting" on page 39
●
"Offset" on page 40
The following settings are available in Spectrum mode only:
Spectrum Mode (Option R&S RTH-K18)