User Manual

Spectrum Analysis
R&S
®
Scope Rider RTH
122User Manual 1326.1578.02 ─ 08
State
Enables or disables the spectrum cursor measurement.
Remote command:
SPECtrum:CURSor<m>:STATe on page 311
Trace Source
Selects the trace on which the cursors are placed. Only active traces are available (see
"Trace mode (Clear/Write/ Max Hold/ Min Hold/Average )" on page 115).
Remote command:
SPECtrum:CURSor<m>:SOURce on page 312
Cursor Value
Determines whether the absolute measured results at each cursor position are dis-
played, or the delta between the cursors.
Remote command:
SPECtrum:CURSor<m>:FREQuency[:VALue] on page 313
SPECtrum:CURSor<m>:FREQuency:DELTa? on page 313
SPECtrum:CURSor<m>:LEVel[:VALue]? on page 313
SPECtrum:CURSor<m>:LEVel:DELTa? on page 313
Track Scaling
If enabled, the position of the cursor lines is adjusted if the vertical or horizontal scales
are changed. The cursor lines keep their relative position to the waveform.
If disabled, the cursor lines remain on their position on the display if the scaling is
changed.
Remote command:
SPECtrum:CURSor<m>:SCPLing on page 312
Coupling
Couples the cursor lines so that the distance between the two lines remains the same
if one cursor is moved.
Remote command:
SPECtrum:CURSor<m>:COUPling on page 312
Spectrum Mode (Option R&S
RTH-K18)