User Manual

Multimeter Measurements
R&S
®
Scope Rider RTH
137User Manual 1326.1578.02 ─ 08
6 Multimeter Measurements
The 4-channel R&S RTH1004 has 4 software-based voltmeters, which can measure in
parallel. For each voltmeter you can select the source and measurement type. See
Voltmeter (R&S RTH1004).
The 2-channel R&S RTH1002 has a hardware-based digital multimeter with two sepa-
rate banana plug inputs for various multimeter measurements. Except for voltages, the
DMM can also measure resistance, capacitance, temperature and more. See Digital
Multimeter (R&S RTH1002).
6.1 Digital Multimeter (R&S RTH1002)
The hardware-based digital multimeter features various multimeter measurements.
Except for voltages, the DMM can also measure resistance, capacitance, temperature
and more.
The R&S RTH can run one DMM measurement at a time, the maximum resolution is
10000 counts and 4 digits.
In "Meter" mode, a separate self-alignment of the meter inputs is available, see Chap-
ter 12.3, "Selfalignment", on page 234.
All remote commands for configuration and measuring are listed in Chapter 14.7, "Digi-
tal Multimeter (R&S RTH1002)", on page 330.
6.1.1 Accessing the Meter Mode
► There are several ways to start the multimeter mode:
● Press the DMM key.
● Press the MODE key, and select "Meter".
● To start relative measurements, press the DMM REL key.
The multimeter interface is displayed, and the measurement is started immediately.
Digital Multimeter (R&S RTH1002)