User Manual

Multimeter Measurements
R&S
®
Scope Rider RTH
139User Manual 1326.1578.02 ─ 08
2. Select the "Meter" mode.
3. Select the measurement type (no. 9 in Figure 6-1).
4. To set the range mode to autoranging or manual range setup, press AUTOSET.
5. If you are in manual range mode, adjust the measurement range: Press the
RANGE keys.
6. For current and temperature measurements, adjust the "Probe Setting".
7. For continuity measurement, adjust the "Resistance Threshold".
8. If you want to get relative result values:
a) Activate "Relative" (no. 10).
b) To set a user-defined reference value, open the "Meter" menu.
c) Activate "Reference", and enter the value in "Reference Manual".
9. To stop the meter measurement, press the RUN STOP key.
The status "Hold" is displayed on the upper left. Stopping the measurement does
not delete statistical values. The measurement continues when you press RUN
STOP again.
6.1.4 Settings
Access: "Meter" menu
Figure 6-2: Digital multimeter settings
Meter Type
Sets the measurement type for the multimeter.
Meter icon "Meter Type" Description
"V AC" AC voltage measurement
"V DC" DC voltage measurement
"V AC+DC" AC+DC voltage (RMS) measurement
Digital Multimeter (R&S RTH1002)