User Manual

Multimeter Measurements
R&S
®
Scope Rider RTH
141User Manual 1326.1578.02 ─ 08
Remote command:
Chapter 14.7.3, "Relative Measurements", on page 338...
Reference/Reference Manual
"Reference" activates or deactivates the setting of a manual reference value.
If active, enter the reference value in "Reference Manual".
Restart Test
Restarts the measurement.
RANGE / POS
In meter mode, the vertical RANGE and POS keys adjust the DMM measurement
range.
Remote command:
Chapter 14.7.2, "Measurement Configuration", on page 331
6.2 Voltmeter (R&S RTH1004)
The software-based voltmeter features AC, DC, AC+DC voltage measurements. Cur-
rent measurements are also possible if you use a shunt resistor or I/U converter.
The R&S RTH can run four voltmeter measurement in parallel, the maximum resolution
is 999 counts and 3 digits.
All remote commands for configuration and measuring are listed in Chapter 14.8, "Volt-
meter (R&S RTH1004)", on page 346.
6.2.1 Accessing the Meter Mode
1. Press the MODE key.
2. Select "Meter".
The multimeter interface is displayed.
Voltmeter (R&S RTH1004)