User Manual

Multimeter Measurements
R&S
®
Scope Rider RTH
146User Manual 1326.1578.02 ─ 08
Input Signal
Selects the channel which is measured by the selected meter.
Remote command:
METer<m>:SENSe:SOURce on page 347
Relative
Activates or deactivates relative measurement. If you activate this function, the cur-
rently measured value is taken as reference value. Instead of the bargraph, the refer-
ence value and the measured value are displayed (see Figure 6-6). You can also set a
desired value as reference value, see "Reference/Reference Manual" on page 146.
Figure 6-6: Relative measurement
1 = Reference value
2 = Measured value relative to reference value
Remote command:
Chapter 14.8.3, "Relative Measurements", on page 351
Reference/Reference Manual
"Reference" activates or deactivates the manual reference value.
If active, enter the reference value in "Reference Manual".
Restart Test
Restarts the measurement and also restarts statistical calculation.
RANGE / POS
In meter mode, the vertical RANGE and POS keys adjust the measurement range of
the selected channel.
Remote command:
Chapter 14.8.2, "Measurement Configuration", on page 347
Voltmeter (R&S RTH1004)