User Manual

Data Logging
R&S
®
Scope Rider RTH
155User Manual 1326.1578.02 ─ 08
Horizontal Scale
Sets the horizontal scale of the horizontal axis for all logged signals, in seconds per
division.
Remote command:
LOGGer:ZOOM:SCALe on page 369
Position, Position Date
Sets the position of the zoomed area in relation to the left side of the display.
Remote command:
LOGGer:Zoom:POSition? on page 370
7.5.3 Logger Statistics
Figure 7-7: Logger statistics
1 = Measurement results; display depends on the logger mode and the selected measurement
2 = Mean value statistic
3 = Standard deviation statistic
Statistics are only shown if a single log is displayed.
Remote commands for logger statistics:
●
LOGGer:RECording:STARt? on page 370
●
LOGGer:RECording:TOTal? on page 370
●
LOGGer:MEASurement<m>:RESult:CURRentsampl? on page 371
●
LOGGer:MEASurement<m>:RESult:MAXimum:POSition? on page 371
●
LOGGer:MEASurement<m>:RESult:MAXimum:VALue? on page 371
●
LOGGer:MEASurement<m>:RESult:MINimum:POSition? on page 371
●
LOGGer:MEASurement<m>:RESult:MINimum:VALue? on page 372
●
LOGGer:MEASurement<m>:RESult:MEAN? on page 372
●
LOGGer:MEASurement<m>:RESult:STDDev? on page 372
●
LOGGer:MEASurement<m>:ENABled? on page 372
●
LOGGer:MEASurement<m>:TYPE? on page 373
●
LOGGer:MEASurement<m>:SOURce? on page 373
7.5.4 Loading Logged Data
Logged data can be loaded from the slot, in which they were stored.
Analyzing Logged Data