User Manual

Protocol Analysis
R&S
®
Scope Rider RTH
162User Manual 1326.1578.02 ─ 08
Figure 8-1: Bus menu. Left: for protocols without address (SPI, UART). Right: for protocols with
address or identifier (I²C, CAN, LIN)
For all serial protocols, the following settings are required:
State
Enables the decoding and the display of the serial bus data.
Remote command:
BUS[:STATe] on page 375
Bus Protocol
Defines protocol type of the bus for configuration and trigger settings.
Remote command:
BUS:TYPE on page 374
Display Format
Sets the decoding format of the data: binary, hexadecimal, decimal, octal, or ASCII.
Remote command:
BUS:FORMat on page 375
Display Labels
Activates the last loaded label list ans shows the label in the decoding results (comb
display and protocol table).
Basics of Protocol Analysis