User Manual

Protocol Analysis
R&S
®
Scope Rider RTH
201User Manual 1326.1578.02 ─ 08
Identifier Pattern
Specifies the identifier pattern to be found, in binary or hex format. Enter the pattern in
MSB first bit order.
See also Chapter 2.5.12.1, "Pattern Definition", on page 66.
Remote command:
TRIGger:LIN:IDENtifier on page 414
Identifier Relation
Defines how the specified identifier pattern is compared with the acquired signal. The
instrument triggers if the acquired address is equal or unequal the defined pattern.
Remote command:
TRIGger:LIN:ICONdition on page 414
Identifier from Label
If a label list with node names was loaded and applied in the bus configuration, you
can select the node name from the list instead of entering the numeric identifier.
The instrument triggers on the identifier of the selected node.
Data Pattern
Specifies the data pattern to be found, in binary or hex format. Enter the pattern in
MSB first bit order.
See also Chapter 2.5.12.1, "Pattern Definition", on page 66.
Remote command:
TRIGger:LIN:DATA on page 414
Data Relation
Defines how the specified data pattern is compared with the acquired signal. The
instrument triggers if the acquired address is equal or unequal the defined pattern.
Remote command:
TRIGger:LIN:DCONdition on page 414
8.6.4 LIN Label List
Label lists are protocol-specific. Label lists for LIN are available in CSV and PTT for-
mat.
A LIN label file contains two values for each identifier:
●
Identifier value
●
Symbolic name for the identifier
Example of a LIN PTT file
# ----------------------------------------------------------------------------
@FILE_VERSION = 1.0
@PROTOCOL_NAME = lin
# ----------------------------------------------------------------------------
# Labels for LIN protocol
LIN (Option R&S RTH-K3)