User Manual

Frequency Counter (R&S RTH-K33)
R&S
®
Scope Rider RTH
214User Manual 1326.1578.02 ─ 08
Remote command:
COUNter<m>:SENSe:TRIGger:MODE on page 364
COUNter<m>:INITiate on page 362
COUNter<m>:ABORt on page 359
Current Result
The currently measured counter frequency.
Remote command:
COUNter<m>:READ? on page 363
COUNter<m>:FETCh? on page 361
COUNter<m>:MEASure:FREQuency? on page 362
Minimum
The minimum of all measured counter frequencies since statistics were last restarted.
Remote command:
COUNter<m>:CALCulate:AVERage:MINimum? on page 360
COUNter<m>:CALCulate:AVERage:ALL? on page 359
Maximum
The maximum of all measured counter frequencies since statistics were last restarted.
Remote command:
COUNter<m>:CALCulate:AVERage:MAXimum? on page 360
COUNter<m>:CALCulate:AVERage:ALL? on page 359
Average
The average of all measured counter frequencies since statistics were last restarted.
Remote command:
COUNter<m>:CALCulate:AVERage:AVERage? on page 359
COUNter<m>:CALCulate:AVERage:ALL? on page 359
10.3 Performing a Counter Measurement
To perform a basic counter measurement without a reference
1. Before you can perform a counter measurement, adjust the waveforms by editing
the vertical, horizontal, trigger and acquisition settings.
For details see:
● Chapter 2.2, "Vertical Setup", on page 38
● Chapter 2.3, "Horizontal Setup", on page 42
● Chapter 2.5, "Trigger", on page 46
● Chapter 2.4, "Acquisition Control", on page 43
2. To adjust the instrument settings to the current input signal automatically, press
AUTOSET.
Performing a Counter Measurement