User Manual

Remote Control Commands
R&S
®
Scope Rider RTH
252User Manual 1326.1578.02 ─ 08
14.3 Waveform Setup
● Automatic Setup....................................................................................................252
● Vertical Setup........................................................................................................252
● Horizontal Setup....................................................................................................257
● Acquisition Control................................................................................................ 258
● Trigger...................................................................................................................260
14.3.1 Automatic Setup
AUToscale
Performs an autoset in scope mode.
Usage:
Event
14.3.2 Vertical Setup
The channel suffix <m> selects the channel for which the command is executed. The
number of channels depends on the instrument type. The R&S RTH1004 has 4 chan-
nels, the suffix values are 1 | 2 | 3 | 4. The R&S RTH1002 has 2 channels, the suffix
values are 1 | 2.
Set the attenuation factor of the probe manually on the display when you attach the
probe: "Vertical" > "Probe Setting". There is no remote command for probe setup.
Make sure to set the attenuation factor on the instrument according to the probe being
used. Otherwise, the measurement results do not reflect the actual voltage level, and
you might misjudge the actual risk.
CHANnel<m>:STATe..................................................................................................... 252
CHANnel<m>:SCALe..................................................................................................... 253
CHANnel<m>:RANGe.................................................................................................... 253
CHANnel<m>:POSition...................................................................................................253
CHANnel<m>:OFFSet.................................................................................................... 254
CHANnel<m>:COUPling.................................................................................................254
CHANnel<m>:BANDwidth...............................................................................................254
CHANnel<m>:DESKew.................................................................................................. 255
CHANnel<m>:THReshold:TECHnology............................................................................255
CHANnel<m>:THReshold:USER..................................................................................... 256
CHANnel<m>:THReshold:THReshold?............................................................................ 256
CHANnel<m>:THReshold:FINDlevel................................................................................ 257
CHANnel<m>:STATe <State>
Switches the channel signal on or off.
Waveform Setup