User Manual

Remote Control Commands
R&S
®
Scope Rider RTH
265User Manual 1326.1578.02 ─ 08
TRIGger:GLITch:RANGe <Condition>
Selects the glitches to be identified: shorter or longer than the width specified with
TRIGger:GLITch:WIDTh.
Parameters:
<Condition> LONGer | SHORter
*RST: LONGer
TRIGger:GLITch:WIDTh <Duration>
Sets the pulse width of the glitch.
Parameters:
<Duration> Range: 800E-12 to 10000
Increment: 100E-9
*RST: 5E-9
Default unit: s
14.3.5.4 Width Trigger
See also Chapter 2.5.4, "Width Trigger", on page 51.
TRIGger:WIDTh:POLarity............................................................................................... 265
TRIGger:WIDTh:RANGe.................................................................................................265
TRIGger:WIDTh:WIDTh..................................................................................................266
TRIGger:WIDTh:DELTa..................................................................................................266
TRIGger:WIDTh:MAX.....................................................................................................266
TRIGger:WIDTh:MIN...................................................................................................... 267
TRIGger:WIDTh:POLarity <Polarity>
Sets the pulse polarity, that is the direction of the first pulse slope. You can trigger on:
●
Positive going pulses. The width is defined from the rising to the falling edge.
●
Negative going pulses. The width is defined from the falling to the rising edge.
●
Both positive and negative going pulses
Parameters:
<Polarity> POSitive | NEGative | EITHer
*RST: POSitive
TRIGger:WIDTh:RANGe <Condition>
Defines how the measured pulse width is compared with the given limit(s).
Waveform Setup