Manualshelf

User Manual

ManualsBrandsRohde & Schwarz ManualsOscilloscope Test Probes (Voltage / Frequency)Passive Probe, 100:1, 500MHz, 1kV
301302303304305306307308309310
Remote Control Commands
R&S
®
Scope Rider RTH
271User Manual 1326.1578.02 ─ 08
TRIGger:EXTernal:SLOPe <Slope>
Sets the edge direction for the trigger. You can trigger on the rising edge, the falling
edge, or riding and falling edges of the external signal.
Parameters:
<Slope> POSitive | NEGative | EITHer
*RST: POSitive
14.3.5.7 Pattern Trigger (R&S RTH-K19)
See also Chapter 2.5.7, "Pattern Trigger (R&S RTH-K19)", on page 58.
TRIGger:PATTern:STATe[:CHANnel<m>]........................................................................ 271
TRIGger:PATTern:STATe:COMBination...........................................................................271
TRIGger:PATTern:WIDTh:RANGe...................................................................................272
TRIGger:PATTern:TIMeout[:TIME]...................................................................................272
TRIGger:PATTern:WIDTh[:WIDTh].................................................................................. 272
TRIGger:PATTern:WIDTh:DELTa.................................................................................... 273
TRIGger:PATTern:WIDTh:MINWidth................................................................................273
TRIGger:PATTern:WIDTh:MAXWidth...............................................................................273
TRIGger:PATTern:STATe[:CHANnel<m>] <State>
Sets the state of each input channel. The channel is specified by the channel suffix:
The logical combination of the channel states is defined by TRIGger:PATTern:
STATe:COMBination.
Suffix:
<m>
.
1..4: analog channel 1 to 4
8..15: digital channels D0 to D7
Parameters:
<State> ONE | ZERO | DONTcare
ONE
The signal value is above the defined threshold.
ZERO
The signal value is below the defined threshold.
DONTcare
The signal state does not matter.
*RST: DONTcare
TRIGger:PATTern:STATe:COMBination <ChCombination>
Sets the logical combination for all active channels. The required state of each channel
is defined by TRIGger:STATe:CHANnel<m>.
Waveform Setup