User Manual

Remote Control Commands
R&S
®
Scope Rider RTH
275User Manual 1326.1578.02 ─ 08
TRIGger:LEVel<m>:RUNT:LOWer...................................................................................275
TRIGger:LEVel<m>:RUNT:UPPer................................................................................... 275
TRIGger:RUNT:POLarity................................................................................................ 275
TRIGger:RUNT:RANGe..................................................................................................275
TRIGger:RUNT:WIDTh...................................................................................................276
TRIGger:RUNT:DELTa...................................................................................................276
TRIGger:RUNT:MINWidth...............................................................................................276
TRIGger:RUNT:MAXWidth..............................................................................................277
TRIGger:LEVel<m>:RUNT:LOWer <LowerLevel>
TRIGger:LEVel<m>:RUNT:UPPer <UpperLevel>
Set the upper and lower levels that limit the runt.
Suffix:
<m>
.
1..4
Indicates the trigger source: analog channel 1 to 4
Parameters:
<LowerLevel>
<UpperLevel>
Range: -10 to 10
Increment: 1E-3
*RST: 0
Default unit: V
TRIGger:RUNT:POLarity <Polarity>
Sets the pulse polarity, that is the direction of the first pulse slope. You can trigger on:
●
Positive going pulses. The width is defined from the rising to the falling edge.
●
Negative going pulses. The width is defined from the falling to the rising edge.
●
Both positive and negative going pulses
Parameters:
<Polarity> POSitive | NEGative | EITHer
*RST: POSitive
TRIGger:RUNT:RANGe <Condition>
Defines an additional time limit of the runt pulse.
Waveform Setup