User Manual

Remote Control Commands
R&S
®
Scope Rider RTH
277User Manual 1326.1578.02 ─ 08
TRIGger:RUNT:MAXWidth <MaxDuration>
Sets the upper time limit of the runt for comparisons WITHin and OUTSide.
Parameters:
<MaxDuration> Range: 800E-12 to 10000
Increment: 100E-9
*RST: 5E-9
Default unit: s
14.3.5.10 Slew Rate Trigger (R&S RTH-K19)
See also Chapter 2.5.10, "Slew Rate Trigger (R&S RTH-K19)", on page 63.
TRIGger:LEVel<m>:SLEW:LOWer...................................................................................277
TRIGger:LEVel<m>:SLEW:UPPer................................................................................... 277
TRIGger:SLEW:SLOPe.................................................................................................. 277
TRIGger:SLEW:RANGe..................................................................................................277
TRIGger:SLEW:RATE.................................................................................................... 278
TRIGger:SLEW:DELTa...................................................................................................278
TRIGger:SLEW:MINWidth...............................................................................................278
TRIGger:SLEW:MAXWidth..............................................................................................279
TRIGger:LEVel<m>:SLEW:LOWer <Level>
TRIGger:LEVel<m>:SLEW:UPPer <Level>
Set the upper and lower voltage thresholds, respectively. The time measurement starts
when the signal crosses the first trigger level - the upper or lower level depending on
the selected slope - and stops when the signal crosses the second level.
Suffix:
<m>
.
1..4
Indicates the trigger source: analog channel 1 to 4
Parameters:
<Level> Range: -10 to 10
Increment: 1E-3
*RST: 0
Default unit: V
TRIGger:SLEW:SLOPe <Slope>
Sets the edge direction for the trigger.
Parameters:
<Slope> POSitive | NEGative | EITHer
*RST: POSitive
TRIGger:SLEW:RANGe <Condition>
Defines the time limits of the slew rate.
Waveform Setup