User Manual

Remote Control Commands
R&S
®
Scope Rider RTH
279User Manual 1326.1578.02 ─ 08
TRIGger:SLEW:MAXWidth <MaxDuration>
Sets the upper time limit of the transition time for comparisons WITHin and OUTSide.
Parameters:
<MaxDuration> Range: 800E-12 to 10000
Increment: 100E-9
*RST: 5E-9
Default unit: s
14.3.5.11 Data2Clock Trigger (R&S RTH-K19)
See also Chapter 2.5.11, "Data2Clock Trigger (R&S RTH-K19)", on page 64.
TRIGger:DATatoclock:DSOurce[:VALue]..........................................................................279
TRIGger:DATatoclock:CSOurce[:VALue]..........................................................................279
TRIGger:DATatoclock:CSOurce:EDGE............................................................................ 279
TRIGger:DATatoclock:CONDition.................................................................................... 279
TRIGger:DATatoclock:HTIMe..........................................................................................280
TRIGger:DATatoclock:STIMe.......................................................................................... 280
TRIGger:DATatoclock:DSOurce[:VALue] <Source>
Selects the input channel of the data signal.
Parameters:
<Source> C1 | C2 | C3 | C4 | D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7
*RST: C1
TRIGger:DATatoclock:CSOurce[:VALue] <Source>
Selects the input channel of the clock signal.
Parameters:
<Source> C1 | C2 | C3 | C4 | D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7
*RST: C1
TRIGger:DATatoclock:CSOurce:EDGE <Slope>
Sets the edge of the clock signal: rising (POSitive), falling (NEGative), or both
edges (EITHer). The time reference point for the setup and hold time is the crossing
point of the clock edge and the trigger level.
Parameters:
<Slope> POSitive | NEGative | EITHer
*RST: POSitive
TRIGger:DATatoclock:CONDition <TrigCondition>
Selects how a violation of the setup and hold time is handled.
Waveform Setup