User Manual

Remote Control Commands
R&S
®
Scope Rider RTH
290User Manual 1326.1578.02 ─ 08
Return values:
<ResultLimit> INSide | OVERflow | UNDerflow | OVUNflow
*RST: INSide
Usage: Query only
14.4.3 Cursor Measurements
The following commands are required for common R&S RTH cursor measurements.
Special commands are available for Spectrum mode, see Chapter 14.6.2.2, "Cursor
Measurements in Spectrum Mode", on page 311.
● Cursor Settings..................................................................................................... 290
● Cursor Measurement Results............................................................................... 292
14.4.3.1 Cursor Settings
CURSor:STATe............................................................................................................. 290
CURSor:FUNCtion......................................................................................................... 290
CURSor:SOURce...........................................................................................................290
CURSor:COUPling.........................................................................................................291
CURSor:SCPLing...........................................................................................................291
CURSor:SCReen........................................................................................................... 291
CURSor:MEASurement<m>:TYPE.................................................................................. 291
CURSor:STATe <State>
Enables or disables the cursor measurement.
Parameters:
<State> ON | OFF
*RST: OFF
CURSor:FUNCtion <Type>
Defines the type of the cursor measurement.
Parameters:
<Type> VERTical | HORizontal | TRACking | MEASure
See Chapter 3.3.2, "Cursor Types and Results", on page 82.
*RST: VERTical
CURSor:SOURce <Source>
Defines the source on which the cursor measurement is performed. The source setting
is not relevant for the vertical cursor type.
Waveform Analysis