User Manual

Remote Control Commands
R&S
®
Scope Rider RTH
308User Manual 1326.1578.02 ─ 08
●
SPECtrum:FREQuency:SPAN[:VALue] on page 306
●
SPECtrum:FREQuency:WINDow:TYPE on page 307
●
SPECtrum:FREQuency:MAGNitude:SCALe on page 305
Commands specific to the Spectrum mode:
● Configuring the Measurement...............................................................................308
● Cursor Measurements in Spectrum Mode............................................................ 311
● Markers in Spectrum Mode...................................................................................314
● Exporting Spectrum Analysis Results................................................................... 318
14.6.2.1 Configuring the Measurement
SPECtrum:MODE?.........................................................................................................308
SPECtrum:FREQuency:AVERage:COUNt........................................................................308
SPECtrum:FREQuency:BANDwidth[:RESolution]:AUTO.................................................... 309
SPECtrum:FREQuency:BANDwidth[:RESolution]:RATio.................................................... 309
SPECtrum:FREQuency:FULLspan...................................................................................309
SPECtrum:FREQuency:MAGNitude:REFerence[:VALue]................................................... 309
SPECtrum:FREQuency:POSition.....................................................................................310
SPECtrum:FREQuency:SCALe....................................................................................... 310
SPECtrum:WAVeform:AVERage[:ENABle]....................................................................... 310
SPECtrum:WAVeform:MAXimum[:ENABle].......................................................................311
SPECtrum:WAVeform:MINimum[:ENABle]........................................................................311
SPECtrum:WAVeform:SPECtrum[:ENABle]...................................................................... 311
SPECtrum:FREQuency:RESet........................................................................................ 311
SPECtrum:MODE?
Queries the most recently activated spectrum analysis mode.
Return values:
<Mode> FFT | SPECtrum
*RST: FFT
Usage: Query only
SPECtrum:FREQuency:AVERage:COUNt <NoOfAvgs>
Defines the number of measurements to average for the average trace (see
SPECtrum:WAVeform:AVERage[:ENABle] on page 310).
Parameters:
<NoOfAvgs> Range: 2 to 1024
Increment: 2
*RST: 64
Spectrum Analysis