User Manual

Remote Control Commands
R&S
®
Scope Rider RTH
311User Manual 1326.1578.02 ─ 08
SPECtrum:WAVeform:MAXimum[:ENABle] <State>
Displays the "Max Hold" spectrum trace.
Parameters:
<State> ON | OFF
*RST: OFF
SPECtrum:WAVeform:MINimum[:ENABle] <State>
Displays the "Min Hold" spectrum trace.
Parameters:
<State> ON | OFF
*RST: OFF
SPECtrum:WAVeform:SPECtrum[:ENABle] <State>
Displays the clear/write spectrum trace.
Parameters:
<State> ON | OFF
*RST: ON
SPECtrum:FREQuency:RESet
Clears the results for previous measurements used in statistical evaluation (see
SPECtrum:WAVeform:AVERage[:ENABle], SPECtrum:WAVeform:MAXimum[:
ENABle], SPECtrum:WAVeform:MINimum[:ENABle] and SPECtrum:
FREQuency:AVERage:COUNt on page 308).
Usage:
Event
14.6.2.2 Cursor Measurements in Spectrum Mode
Special cursor commands are available for the Spectrum mode.
SPECtrum:CURSor<m>:STATe.......................................................................................311
SPECtrum:CURSor<m>:SOURce....................................................................................312
SPECtrum:CURSor<m>:COUPling.................................................................................. 312
SPECtrum:CURSor<m>:SCPLing....................................................................................312
SPECtrum:CURSor<m>:FREQuency[:VALue]...................................................................313
SPECtrum:CURSor<m>:FREQuency:DELTa?.................................................................. 313
SPECtrum:CURSor<m>:LEVel[:VALue]?..........................................................................313
SPECtrum:CURSor<m>:LEVel:DELTa?........................................................................... 313
SPECtrum:CURSor<m>:SCReen.................................................................................... 314
SPECtrum:CURSor<m>:STATe <State>
Enables or disables the spectrum cursor measurement.
Spectrum Analysis