User Manual

Remote Control Commands
R&S
®
Scope Rider RTH
319User Manual 1326.1578.02 ─ 08
14.6.3 Harmonic Mode (R&S RTH-B34)
To activate Harmonic mode, use OP HARM (see OP[:MODE] on page 251).
The following commands are only available if the Harmonic Analysis option R&S RTH-
B34 is installed.
● Configuring Harmonic Measurements...................................................................319
● Retrieving and Exporting Harmonic Results......................................................... 323
14.6.3.1 Configuring Harmonic Measurements
HARMonic:AVERage......................................................................................................319
HARMonic:CLEar...........................................................................................................319
HARMonic:DISPlay:TYPE...............................................................................................319
HARMonic:DISPlay:USER.............................................................................................. 320
HARMonic:FUNDamental:CURRent?...............................................................................320
HARMonic:FUNDamental:TYPE......................................................................................320
HARMonic:FUNDamental:USER..................................................................................... 321
HARMonic:LIMits:CURRent?...........................................................................................321
HARMonic:LIMits:LOAD..................................................................................................321
HARMonic:LIMits:NAME.................................................................................................322
HARMonic:LIMits:TYPE..................................................................................................322
HARMonic:SCALe..........................................................................................................322
HARMonic:STATistic...................................................................................................... 322
HARMonic:THDType...................................................................................................... 323
HARMonic:AVERage <Average>
Determines the number of measurements for which the results are averaged. By
default, no averaging is performed.
Parameters:
<Average> OFF | AV2 | AV4 | AV8 | AV16 | AV32
*RST: OFF
HARMonic:CLEar
Clears the results for previous measurements used in statistical evaluation (see
HARMonic:AVERage on page 319 and HARMonic:STATistic on page 322).
Usage:
Event
HARMonic:DISPlay:TYPE <Selection>
Determines the number of harmonics to be displayed in the bargraph.
Note that this setting only affects the graphical result display; it has no effect on the
selection of harmonics for which results are provided during a file export (manually or
via remote command). For that purpose, use HARMonic:LIMits:TYPE on page 322.
Spectrum Analysis