User Manual

Remote Control Commands
R&S
®
Scope Rider RTH
340User Manual 1326.1578.02 ─ 08
METer:SENSe:RESistance:NULL:VALue <ReferenceValue>
Sets the reference value for resistance measurements. The measurement result is the
difference of the measured sample and the reference value.
The value takes effect if relative measurement is on, see METer:SENSe:
RESistance:NULL:STATe.
Parameters:
<ReferenceValue> Range: +/- (1.1 * measurement range)
*RST: 0
Default unit: Ohm
METer:SENSe:TEMPerature:NULL:VALue
<ReferenceValue>
Sets the reference value for temperature measurements. The measurement result is
the difference of the measured sample and the reference value.
The value takes effect if relative measurement is on, see METer:SENSe:
TEMPerature:NULL:STATe.
Parameters:
<ReferenceValue> Range: -200 to 850
*RST: 0
Default unit: To define the unit, use METer:UNIT:TEMPerature.
METer<m>:SENSe:NULL:VALU <ReferenceValue>
Sets the reference value for the currently active measurement type.
Relative measurements are not available for diode, continuity, and frequency measure-
ments.
Suffix:
<m>
.
1..4
R&S RTH1002: always 1, omit the suffix
R&S RTH1004: Selects the voltmeter.
Parameters:
<ReferenceValue> Range: +/- (1.1 * measurement range)
Default unit: Depends on the measurement type
14.7.4 Measurement Control
METer:SENSe:FUNCtion................................................................................................341
METer:CONFigure:VALue?.............................................................................................341
METer<m>:TRIGger:MODE............................................................................................ 341
METer<m>:ABORt......................................................................................................... 342
Digital Multimeter (R&S RTH1002)