User Manual

Remote Control Commands
R&S
®
Scope Rider RTH
365User Manual 1326.1578.02 ─ 08
Suffix:
<m>
.
1..2
Parameters:
<TriggerMode> AUTO | SINGle
AUTO
Continuous measurement; the most recent value is preserved
and displayed, while the oldest value are overwritten
SINGle
Single measurement; the continuous measurement is stopped
and the most recent value is preserved.
*RST: AUTO
14.10 Data Logging
● Logger Settings.....................................................................................................365
● Cursor in Logger Mode......................................................................................... 367
● Zoom in Logger mode...........................................................................................369
● Logger Statistics ...................................................................................................370
● Logger Records.....................................................................................................373
14.10.1 Logger Settings
LOGGer:SOURce.......................................................................................................... 365
LOGGer:TIMebase:SRATe............................................................................................. 365
LOGGer:TIMebase:SCALe..............................................................................................366
LOGGer:SLOT:CURRent................................................................................................366
LOGGer:SLOT:LOAD.....................................................................................................366
LOGGer:SLOT:CLEar.....................................................................................................366
LOGGer:ACLR.............................................................................................................. 367
LOGGer:SOURce <Source>
Sets the logger source.
Parameters:
<Source> SCOPe | METer | COUNter
SCOPe: an active automatic measurement is required.
METer | COUNter: The selected measurement must be active,
but not running.
LOGGer:TIMebase:SRATe <NextSampleRate>
Sets the number of samples per second.
Data Logging