User Manual

Remote Control Commands
R&S
®
Scope Rider RTH
367User Manual 1326.1578.02 ─ 08
LOGGer:ACLR
Deletes the log data of all slots. Only possible while logging is stopped.
Usage: Event
14.10.2 Cursor in Logger Mode
14.10.2.1 Cursor Settings
LOGGer:CURSor:STATe................................................................................................ 367
LOGGer:CURSor:TYPE..................................................................................................367
LOGGer:CURSor:SCPLing............................................................................................. 367
LOGGer:CURSor:COUPling............................................................................................368
LOGGer:CURSor:SCReen..............................................................................................368
LOGGer:CURSor:STATe <Enabled>
Enables or disables the logger cursor measurement.
Parameters:
<Enabled> ON | OFF
*RST: OFF
LOGGer:CURSor:TYPE <Value>
If data logging is running for more than 2 days and 7 hours, the logger compresses 4
logging values into a minimum, average and maximum value. The command defines
which of these values are measured at the cursor position.
For logging periods shorter than 2 days and 7 hours, the command is not relevant.
Parameters:
<Value> MINimum | AVERage | MAXimum
*RST: AVERage
LOGGer:CURSor:SCPLing <TrackScaling>
If ON, the position of the cursor lines is adjusted when the horizontal scale is changed.
If OFF, the cursor lines remain on their position on the display when the scaling is
changed.
Parameters:
<TrackScaling> ON | OFF
*RST: OFF
Data Logging