User Manual

Remote Control Commands
R&S
®
Scope Rider RTH
375User Manual 1326.1578.02 ─ 08
Parameters:
<Protocol> I2C | SPI | UART | CAN | LIN
*RST: I2C
BUS[:STATe] <State>
Enables the decoding and the display of the serial bus data.
Parameters:
<State> ON | OFF
*RST: OFF
BUS:FORMat <NumberFormat>
Sets the decoding format of the data.
Parameters:
<NumberFormat> BIN | OCT | DEC | HEX | ASCii
*RST: HEX
14.11.2 I2C (Option R&S RTH-K1)
● I2C Configuration Settings.................................................................................... 375
● I2C Trigger............................................................................................................ 376
● I2C Decode Results.............................................................................................. 379
14.11.2.1 I2C Configuration Settings
BUS:I2C:SCL:SOURce...................................................................................................375
BUS:I2C:SDA:SOURce.................................................................................................. 375
BUS:I2C:TECHnology.................................................................................................... 376
BUS:I2C:SCL:THReshold............................................................................................... 376
BUS:I2C:SDA:THReshold...............................................................................................376
BUS:SETReflevels......................................................................................................... 376
BUS:I2C:SCL:SOURce <Channel>
BUS:I2C:SDA:SOURce <Channel>
Set the input channels of the I2C lines.
Parameters:
<Channel> C1 | C2 | C3 | C4 | D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7
C3 and C4: only R&S RTH1004
Digital channels are available if option R&S RTH-B1 is installed.
*RST: C1
Protocol Analysis