User Manual

Remote Control Commands

R&S

Scope Rider RTH

396User Manual 1326.1578.02 ─ 08

Parameters:

<StopBits> B1 | B15 | B2

*RST: B1

BUS:UART:ORDer <BitOrder>

Defines if a word starts with MSB (most significant bit) or LSB (least significant bit).

The display of the decoded signal considers this setting, results are displayed in the

specified order.

Parameters:

<BitOrder> LSBF | MSBF

*RST: MSBF

BUS:UART:FRAMemode

IDLE defines frames of several words in the data stream, which are defined by a time-

out between a stop bit and the next start bit. Enter the minimum timeout between two

frames using BUS:UART:TOUT.

Parameters:

<FrameMode> NONE | IDLE

*RST: NONE

BUS:UART:TOUT <IdleTime>

Sets the minimum timeout between two frames if BUS:UART:FRAMemode is set to

IDLE.

Parameters:

<IdleTime> Range: 100E-9 to 1

Increment: 1E-3

*RST: 1E-3

Default unit: s

14.11.4.2 UART Trigger

TRIGger:UART:TYPE.....................................................................................................396

TRIGger:UART:DATA.....................................................................................................397

TRIGger:UART:DCONdition............................................................................................397

TRIGger:UART:TYPE <TriggerType>

Selects the trigger type for UART analysis.

Protocol Analysis