Manualshelf

User Manual

ManualsBrandsRohde & Schwarz ManualsOscilloscope Test Probes (Voltage / Frequency)Passive Probe, 100:1, 500MHz, 1kV
431432433434435436437438439440
Remote Control Commands
R&S
®
Scope Rider RTH
402User Manual 1326.1578.02 ─ 08
Parameters:
<SamplePoint> Range: 10 to 95
Increment: 1
*RST: 50
Default unit: %
14.11.5.2 CAN Trigger
TRIGger:CAN:ACKerror..................................................................................................402
TRIGger:CAN:BITSterror................................................................................................ 402
TRIGger:CAN:CRCerror................................................................................................. 402
TRIGger:CAN:DATA.......................................................................................................403
TRIGger:CAN:DCONdition..............................................................................................403
TRIGger:CAN:FORMerror...............................................................................................403
TRIGger:CAN:FTYPe..................................................................................................... 403
TRIGger:CAN:ICONdition............................................................................................... 404
TRIGger:CAN:IDENtifier................................................................................................. 404
TRIGger:CAN:ITYPe...................................................................................................... 405
TRIGger:CAN:TYPE.......................................................................................................405
TRIGger:CAN:ACKerror <AckError>
An acknowledgement error occurs when the transmitter does not receive an acknowl-
edgment - a dominant bit during the Ack Slot.
Parameters:
<AckError> ON | OFF
*RST: ON
TRIGger:CAN:BITSterror <StuffBitError>
A stuff error occurs when the 6th consecutive equal bit level in the mentioned fields is
detected.
Parameters:
<StuffBitError> ON | OFF
*RST: ON
TRIGger:CAN:CRCerror <CrcError>
A CRC error occurs when the calculated result differs from the received value in the
CRC sequence.
Parameters:
<CrcError> ON | OFF
*RST: ON
Protocol Analysis