User Manual

Getting Started
R&S
®
Scope Rider RTH
11User Manual 1326.1578.02 ─ 08
Shock hazard caused by high voltages
The instrument must be used in an appropriate manner to prevent electric shock, fire,
personal injury, or damage.
●
Do not open the instrument casing.
●
Do not use the instrument if the instrument casing, the display or any probe or
accessory are damaged. If you detect or suspect any damage, have the instrument
or accessory inspected by qualified service personnel.
●
Use only specified probes and accessories that comply with the measurement cat-
egory of your measurement task.
If you use other than Rohde & Schwarz accessories, make sure that they are suita-
ble to the instrument and the measurement task.
●
Do not operate the instrument in wet, damp or explosive atmospheres.
Make sure that all connectors are completely dry before connecting the inputs.
●
Voltages higher than 30 V RMS or 42 V peak or 60 V DC are regarded as hazard-
ous contact voltages. Make sure that only electrically skilled persons may use the
R&S RTH for measurements on hazardous contact voltages because these work-
ing conditions require special education and experience to perceive risks and to
avoid hazards which electricity can create.
●
Observe the operating conditions specified in the data sheet. Note that the general
safety instructions also contain information on operating conditions that will prevent
damage to the instrument.
●
Read and observe the "Basic Safety Instructions" delivered as a printed brochure
with the instrument. In addition, read and observe the safety instructions in the fol-
lowing sections.
1.2.1 Unpacking the Instrument
When you receive your shipping package, unpack and inspect the package and its
contents for damage.
1. Inspect the package for damage.
If the packaging material shows any signs of stress, notify the carrier as well as
your Rohde & Schwarz service center. Keep the package and cushioning material
for inspection. Keep a damaged package and the cushioning material until the con-
tents have been checked for completeness and the instrument has been tested.
2. Unpack the handheld scope and the accessories and check the contents for com-
pleteness, see "Package contents" on page 12.
If anything is missing, contact your Rohde & Schwarz service center.
3. Inspect the handheld scope and the accessories.
If there is any damage or defect, or if the R&S RTH does not operate properly,
notify your Rohde & Schwarz service center.
Preparing for Use