User Manual

Getting Started
R&S
®
Scope Rider RTH
30User Manual 1326.1578.02 ─ 08
Key Press shortly Press and hold
Open or close the "Mode", "File" or "Setup" dialog, respectively.
Saves measurement documentation:
Only screenshot if "one touch" is off. ZIP file
with selected data if "one touch" is on.
Opens or closes the "Screen-
shot" dialog to configure the
screenshot and the "one touch"
output.
All R&S RTH:
Only R&S RTH1004:
The effect depends on the channel state:
If the channel is off, the key switches on the
channel and sets the focus. The key lights up.
If the channel is on but not in focus, the key
sets the focus. The key lights up.
Open or close the "Vertical"
dialog for the corresponding
channel to configure the chan-
nel settings.
Only R&S RTH1002: DMM starts or stops the meter measurements
(same as MODE = "Meter").
DMM REL enables or disables relative meter
measurements.
Opens or closes the "Meter"
dialog to configure the mea-
surements.
TIME and POS adjust the horizontal time scale and position of the trigger point.
RANGE and POS set the vertical scale (vertical sensitivity) and the vertical posi-
tion of the focused waveform (analog or channel, math or reference waveform).
SIGNAL OFF switches off the focused wave-
form.
RUN STOP starts and stops the acquisition.
SETUP opens or closes the "Trigger" dialog to select the trigger type and adjust
the trigger settings.
Operating Basics